2 Pin 8 mm LED Connector IP65 AC-DJ-N8XB-2

This LED Strip Connector Suitable for 2 pin 8mm 3528 STANDARD WATERPROOF led lights(PU surface,not Silicone surface), One end for 2 core extension wire and another end for waterproof single color led strip
Connect led strip to wire: Can DIY custom wiring, without stripping wire, no soldering,Compatible with 20-18awg 2 conductor wire, solid wire or stranded wire, Use these with the 2 core extension wire to get lighting exactly where you want it
No need stripping waterproof coating of led strip before connection , easily connect your led strip to power, dimmer or controller without any soldering, just a pliers needed.
Firmly bite through the strip, don’t like traditional connector only conductive connection, it is a solid connection and much stronger
If your led strip are NON-WATERPROOF or NON-STANDARD WATERPROOF lights(too soft or too thin ), pls use this item AC-SE-N8XB-2

SKU: AC-DJ-N8XB-2 Categories: 2pin 8mm, LED Connector

Description
Reviews (0)

Description

NOTE: 1.Make sure your section of LED light strip is 8MM wide 2 PIN WATERPROOF LED Strip.
2.Ensure your Wire Diameter 20-18AWG and without stripping wire,the wires have to be separated before you insert them into the connector, it also requires pressing down with nose pliers to ensure the contacts pierces through the insulation on the wire.

Firmly bite through led light strip, don’t like traditional connector only conductive connection
Updated version of LED strip connector, assemble wire by yourself as needed, flexible to different project! Both solderless for led strip and wire joint. Just clasp your prepared led strip section into the connector to get connected. worry-free solution for waterproof LED light strip connection and extension needs,extension for whatever the wire length you want to connect.
Solderless Wire Joint Quick Splice Connector for 20-18awg Cable
Our products were an innovative safe and quick wire connector,peeling free,tapping free and twisting free. it greatly changes the way of wire connection .it allow any users to just insert the wire into wire joint and press cover by pliers to connect the wire safely and conveniently.
Installation Instructions:
Strip End:
1.Open the transparent cover of connector up to 90 degrees.
2 .Insert led strip section to the END of led strip connector, put the contact point of led strip on the PINS of the connector.
3. Close the transparent cap with a plier
Wire End :
1.Cut the desired wire length and insert it directly into the guide slot.
2.Make sure that the positive & negative on the led strip light surface are corresponding to the ones on the wires.
3.Close the transparent cap with a plier.
4. End of installation.